How To Tie In A Shed Roof To An Existing Roof

How To Tie In A Shed Roof To An Existing Roof. After nailing down these two boards, dab roofing cement on the nails and along the outside edge. I have roofed before but have never really dealt with (tying) into any existing shingle.

Building a shed roof over a deck
Building a shed roof over a deck from www.decks.com

You want to be about two inches above the very center of. Butt the first new truss against the old one. After framing and sheathing the new addition’s roof, snap a line over the existing roof shingles.

Framing The Porch Roof You Fastening A Patio Roof To The House Hometips How To Build A Shed Roof Over Deck Decks Completed Lean To Shed Attached Existing House Or Garage Wall How To Build A Lean Shed With Pictures Wikihow Framing The Porch Roof You.

I am debating on the idea of removing the shingles around the section that will be covered. The easiest way to tie in the new shingles with the old is with a cut valley (see four ways to shingle a valley). Generally, they are 5/8 inches thick.

Seems That It Would Be A Pain In The Butt, So If I Could Some Advice That Would Be Great.

The joint should be sealed with plenty of roofing compound and then the old tiles need to be replaced. See more ideas about patio roof, backyard patio, patio design. Position the flashing between the two roof pitches.

The Shingles Should Also Match The Existing Roof.

Start rolling out the roof felt followed by shingles. Attaching shed roof to side of house. Then mount new trusses on the new addition walls.

The Spacing Between Each Rafter Depends On Your Building Code.

I have roofed before but have never really dealt with (tying) into any existing shingle. Butt the first new truss against the old one. Slide the right edge of the flashing under the highest roof pitch.

After That, You Need To Install The Sheathing.

Before you attach the value board, you need to make sure that the board covers the porch area. Add decking atop the roof and nail on metal flashing where the shed roof joins the existing roof. You want to be about two inches above the very center of.