How To Start A Gas Fireplace For The First Time

How To Start A Gas Fireplace For The First Time. Dampers are essentially a metal or ceramic plate that sits within the inside top of your fireplace, at the base of the chimney. Tap the switch until the pilot light ignites.

Seafarer Basket Large Home fireplace, Fireplace design
Seafarer Basket Large Home fireplace, Fireplace design from www.pinterest.com

You can run both intermittent pilot ignition fireplaces and standing pilot light systems during a power outage. It’s truly coming from the surfaces of the fireplace,” englund says. Additionally, can you manually light a gas.

Remove The Front Plating Or Open The Access Panel On Your Fireplace Appliance.

A gas fireplace feeds natural gas from a main line into the bottom line of a paneled and insulated fireplace unit. Warm up the air within the chimney. For most units, that will be located at the bottom of the fireplace, just below the protective glass layer of the system.

After Three Hours, Turn The Unit Off.

Lay a row of smaller logs across the logs that you arranged in the previous step.line up your largest logs across the fireplace grate.make sure that the gas is on before turning on your new fireplace. Ipi valve systems will normally have a backup battery system in place to ignite the flames. The first think you want to do is pull the cover off the fireplace.

It’s Truly Coming From The Surfaces Of The Fireplace,” Englund Says.

Fireplace dampers help to stop heat loss from your home when the fireplace isn’t in use. A set of specific instructions must be followed to light a propane fireplace insert correctly. The fireplace is turned on by a pilot light that ignites the gas line under the tempered beads or ceramic logs.

Press The Control Knob Down And Hit The Ignition Switch.

Clear away any cobwebs, sticks and leaves, along with any pests that have found a home in your vent. Many gas fireplaces will work without electricity. The pilot light stays on until needed to create the flames in the fireplace at the touch of a button.

Then, Hit The Fireplace’s Ignition Switch, Which Is Typically A Red Button Located Near The Control Knob.

If you begin to detect a strong odor or notice white smoke coming from the fireplace itself, don’t worry. Dampers are essentially a metal or ceramic plate that sits within the inside top of your fireplace, at the base of the chimney. Most service calls for gas fireplaces cost about $100, and repairs for pilot lights cost $150 on average.