Garage Door Starts To Go Down Then Reverses. The height of the garage door sensors above the garage floor is very important. If there is anything that interrupts or breaks that beam when the garage door is trying to close, the door is going to reverse and go back up.
See how to test the balance of a garage door for more help. The height of the garage door sensors above the garage floor is very important. And the safety reversal feature in garage door openers will not save you in this situation.
Table of Contents
And The Safety Reversal Feature In Garage Door Openers Will Not Save You In This Situation.
Irf i release the button befor the do. The most common reason the door reverses after it touches the floor is the down or close travel needs to be adjusted. Any garage door opener or replacement logic board manufactured after february 3, 2022, will no longer.
The Logic Board Is Your Garage Door Opener’s Brain, And Even With Machines, A Brain Can Wear Out Over Time.
When this happens, you may need to replace it. You need to adjust the. This is almost always the result of a dirty or obstructed safety feature.
If Your Garage Door Opens And Suddenly Stops, It Might Be Because Of Your Logic Board.
The force setting tells the opener how much resistance the door should provide, and if the opener detects more than is allowed, the door will reverse. If the door reverses part way down, and you are sure there is no obstruction or binding, increase the closing force a small amount and try it again. A faulty logic control board.
Replace Them If They're Broken.
This is mainly a concern if you have kids, or live with pets. Look at the photo eyes themselves, if there are cobwebs or if there is dust on the lenses, the eyes will sense this and cause the door reverse. Or maybe it just needs a tweak at the opener.
See How To Test The Balance Of A Garage Door For More Help.
Looks like a down force issue. If your garage door starts to close then reverses back up and blinks, check out this video. Watch our safety sensor troubleshoot video to determine whether the sensors work;